WEEK 10

                                                         WEEK 10

After performing the challenge test5, apart from creating a relay scheme by means of a program in SYSMAC STUDIO to start a motor that works at different speeds through a drive, we had to program an HMI screen that could start the program by touching the HMI screen or display the speed that the engine contained.

We also made an oral presentation in class after successfully completing challenge 5 with a couple of doubts.

When teaching our program and that everything worked, we were proud of the program we did, since everything worked perfectly, except one thing, that for reasons of SYSMAC STUDIO we could not do.

The day after finishing the whole class the presentations and showing what the program was doing, they put us in another challenge.

This challenge will be the fourth challenge of this year, so more or less, we know how to finish everything and be proud of the program we will do.

In this 4 challenge, what we will have is a table, with 4 different PLCs and each table has a few electropneumatic valves, which when activated enable air to pass, creating a linear or circular movement depending on how the cylinders are.